Freds Legs Laminating Sleeves

Tilleggsinformasjon

Her kan du se et utvalg av motiver, gå til leverandøren sin hjemmeside for å se flere design:

Style: Frozen	Style: Superman	Style: Minions
Style: White Lightning	Style: Stars on Black	Style: Swish
Style: Pink Ribbons	Style: Water Mosaic	Style: Gel
Style: Deep Gel	Style: Green Shimmer (shiny)	Style: Blue Shimmer (shiny)
Style: Red Shimmer (shiny)	Style: Pink Thread	Style: It’s Electric
Style: Coral Reef	Style: Fiber Braid	Style: Glass Art
Style: Vapor	Style: Jellyfish	Style: Flowers
Style: Splatter	Style: Aqua Beast	Style: Denim Camo
Style: Wonder Woman	Style: Red Crackle	Style: Dogs
Style: Wood Light	Style: Timber	Style: LV Brown
Style: Sparkle purple	Style: Deep Bloom	Style: Galaxy
Style: Flowers	Style: Denim	Style: Jaguar
Style: Harley	Style: Havana Nights	Style: Black and white qutrefoil
Style: Gold Sparkle	Style: Red Spiderman	Style: Static Yellow

Ortosestørrelser:

Protesestørrelser:

Har du spørsmål vedørende produkt eller bestilling? Kontakt oss på telefon 55 91 88 60 eller post@ortopro.no

Tips for laminating SleeveArt® fabric onto a prosthetic socket or orthotic device

Perform your usual lay-up of Dacron felt (optional), then nyglass or similar, as usual. Then laminate the socket or device. Before you break out the plaster, rough up the outside with sandpaper. Now for the finishing layer: pull one white nylon sock or nyglass and the SleeveArt® fabric over the mold. Use a SleeveArt® laminating sleeve or wrap SleeveArt® fabric around the mold using “Spray 77” adhesive spray. Be sure to work out any wrinkles. Tie off each end. Apply your final PVA bag. Do not use a vacuum hose (nylon) as the final layer, SleeveArt should be your final layer. For a shiny finish, turn the PVA bag inside out before applying then laminate using a clear resin. Use a minimal amount of promoter (don’t set the resin off too fast). Be sure to draw down firmly to remove excess resin with a parachute cord or similar. DO NOT SET RESIN OFF TOO FAST. Slow it down to a 20-30 minute or so lamination. Do not use full suction on vacuum, try half suction. These instructions are vital for best results especially when using the shiny foil fabrics and our custom printed sleeves, because the inks are heat and pressure sensitive.

Please know that if you try to cut corners by doing a single step lamination, you may not be happy with your result